Sonnet-technologies Echo Express SE II User Manual download pdf (Page 10)

Chapter 3 – PCIe Card Installation and Chassis Setup Steps

7. Remove a PCIe card from its packaging, handling the card by its edges

and without touching any components or gold connector pins.

8. Line up the card’s connector with the slot, and then gently but ﬁrmly

press the card straight into the slot; do not rock the card or force the

card into the slot. If you encounter excessive resistance, check the

card’s connector and the slot for damage, and then try inserting the

card again (Figure 4).

9. Secure the card using the screw you removed

previously; do not overtighten the screw

(Figure 4).

10. Repeat steps 7 – 9 with any remaining

cards.

11. Flip the inner assembly back over to its

upright position. Place your hand on

top of the outer case, and then gently

push the inner assembly back into the

outer case (Figure 5).

12. Turn the Echo Express SE II chassis upside-down, and then using the

four screws you removed previously, secure the outer case to the inner

assembly; do not overtighten the screws (Figure 8).

WARNING: When handling computer products, take care to prevent

components from being damaged by static electricity; avoid working

in carpeted areas. Handle expansion cards only by their edges and avoid

touching connector traces and component pins. Also, avoid touching the

Echo Express SE II chassis’ circuit boards and any of its components.

Figure 4

Figure 6

Figure 5

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Sonnet-technologies Echo Express SE II User Manual Page 10